Tribological performance of monolithic copper thin films during nanowear

Bradley M. Schultz, Nan Li, David R. Economy, Julia L. Sharp, Nathan A. Mara, Marian S. Kennedy

Research output: Contribution to journalArticle

3 Scopus citations

Abstract

Mathematical models suggest that the strain along the film formed by parallel passes of a nanoindentation probe in contact with the film can be either homogenous or heterogeneous, depending on contact pressure and spacing between passes. In this study, a 1 µm copper thin film was worn with a cono-spherical diamond probe with normal loads ranging from 25 to 800 µN and wear box edge lengths of 40, 60, and 80 µm. The nanoindenter counterface was rastered across the surface to mimic dry sliding wear. To determine potential strain field changes, 10-step quasi-static indents (200–2000 µN) were performed using nanoindentation inside the wear boxes created at various loads to determine if a strain field alteration could be observed in changes in hardness of the copper thin film. It was shown that there was a softening effect in the hardness for normal loads < 400 µN used during nanowear compared to the as-deposited copper. Normal loads ≥ 400 µN had a similar or higher hardness than the as-deposited copper. This is believed to have occurred due to a relaxation in the residual stresses created during deposition in the copper thin films at lower loads, which caused a decrease in hardness. Conversely, at the higher loads, increased deformation leads to an increase in hardness. Additionally, all of the wear boxes displayed a higher estimated strain hardening exponent than the as-deposited material.

Original languageEnglish (US)
Pages (from-to)50-59
Number of pages10
JournalWear
Volume394-395
DOIs
StatePublished - Jan 15 2018

    Fingerprint

Keywords

  • Hardness
  • Nanoindentation
  • Nanotribology
  • PVD coatings
  • Sliding wear

Cite this

Schultz, B. M., Li, N., Economy, D. R., Sharp, J. L., Mara, N. A., & Kennedy, M. S. (2018). Tribological performance of monolithic copper thin films during nanowear. Wear, 394-395, 50-59. https://doi.org/10.1016/j.wear.2017.10.005